Welcome to Golden Future Enterprise HK ltd.

What problems should be paid attention to when installing high bay lights and maintenance methods

Datetime: 2021-09-16 09:25:00

 

To the front, the distribution of lamps. Reasonably design the installation position of the lamps and lanterns, so that the light source should be reasonably distributed, and no dark areas should appear. The distribution of lamps and lanterns can make people feel that the space is large, bright, without fatigue, and the working environment is comfortable. The construction area should carry out reasonable distribution and selection of LED high bay lights.

Second, when installing and using LED high bay lights, you should pay attention not to press some wires wrongly, because the internal chips or the design of some shells including some lamp tubes are all according to the steps, plus some The intervention of the wire, so when using, it is mainly to be able to perform some related modulations well, so that a better use effect can be achieved.

Third, when installing LED high bay lights, you must first pay attention to electricians must be certified to work, so as to avoid damage to this lamp, before installation, you must also check whether the entire lamp has a certain integrity, whether it can be normal It’s impossible to install without a part. Try to keep a certain installation distance from flammable materials, otherwise there will be some explosions or effects that cannot be used normally.

Fourth, after the installation is completed, the site should be checked to see if there are any blind spots in the lighting. It should be ensured that the lighting of the lamps meets the requirements.

Fifth, when installing the LED high bay light, handle it with care, and don't drop it randomly and cause damage to the light. Strictly follow the installation instructions required by the manufacturer.

1. When buying back the high bay light, don't be busy installing it first, you should carefully read the markings of the lamp and browse the installation manual, and then install and use the high bay light according to the instructions, otherwise it may cause danger.

2. When cleaning and protecting, you should be careful not to change the structure of the industrial and mining lamp, and do not randomly replace the parts of the industrial and mining lamp. After the cleaning and protection, you should install the lamp as it is, and do not miss or wrongly install the lamp parts.

3. In order to extend the service life of the industrial and mining lamp, the maintenance must be strengthened. Wipe often with a dry cloth, and pay attention to avoid moisture intrusion, to avoid corrosion damage or leakage short-circuit phenomenon after a long time; Wipe diligently to avoid affecting the penetration of light.