Welcome to Golden Future Enterprise HK ltd.

Features of explosion-proof and anti-corrosion fluorescent lamps, selection guide

Datetime: 2021-11-03 15:58:00

 

     The explosion-proof and anti-corrosion fluorescent lamp adopts advanced surface treatment technology, which can prevent rain, water spray, and the lamp housing will never corrode. Multiple shock absorption and pressure reduction measures ensure that the lamp can work reliably in harsh environments such as severe vibration and strong wind. Good lighting effect, lighting The scope is large. There is still a lot of knowledge about explosion-proof and anti-corrosion fluorescent lamps. Below, Yangzhong Hengyuan Lighting introduces the characteristics and selection guide of explosion-proof and anti-corrosion fluorescent lamps.

Features of explosion-proof and anti-corrosion fluorescent lamps

The explosion-proof and anticorrosive fluorescent lamp shell is made of reinforced carbonate material, which has the characteristics of high strength, strong impact resistance, high temperature resistance and cold resistance;

The explosion-proof and anti-corrosion fluorescent light source adopts a new generation of T5 ultra-fine fluorescent lamp, which has the following characteristics:

A) Short length, with more accurate light control;

B) High luminous efficiency, more in line with the actual lighting environment, the luminous efficiency of the tube can be as high as 1041m/W;

C) It has a long switching times and service life, with a service life of up to 20,000 hours;

D) It has a high lumen maintenance rate, slow light decay, and the lumen maintenance rate is as high as 92% after 10,000 hours;

E) Improve light speed distribution, high color rendering, energy saving and environmental protection. The luminous flux of 28W T5 tube is greater than that of 36W T8 tube.

Selection Guide for Explosion-proof and Corrosion-proof Fluorescent Lamps

1. The light source has been configured when the lamp leaves the factory, and the user can use it when it is connected to the power supply;

2. When double-tube fluorescent lamps are used for emergency lighting, only one tube will light up;

3. The conventional supply of boom type installation is the side entry line, if you need to add the line entry, please indicate it when ordering.