The charging management circuit is installed in the base of the cordless miner\'s lamp. The charging converter can be used to charge with a regulated charging rack.

When charging, turn off the miner\'s lamp power. Open the miner\'s lamp charging cover to expose the DC jack. Plug the charger\'s charging jack into the DC jack and plug the other end of the charger into a 220V AC power source.

During normal charging, the indicator light of the charger is red.If the battery is full, the indicator light will turn to green and stops charging automatically. The normal charging time is about 6-8 hours.

The newly purchased miner\'s lamp cannot be used directly and should be discharged first. After discharging, charge on the charging stand again, the time is not less than 7 hours.

The use of other charging methods should be approved by the company, otherwise the product may be damaged due to mismatched charging.

When in use, press the power switch on the lamp head to turn on the main and auxiliary light sources and turn off the light source respectively.

The main light source of the miner\'s lamp can be used for more than 11 hours. if it exceeds the scheduled working time, please switch to the auxiliary light source in time to maintain a longer lighting time.

The miner\'s lamp is equipped with an over-discharge control circuit. With normal conditions, the battery will not cause over-discharge. However, when the battery is discharged to the end voltage of 2.75V, the over-discharge control circuit starts.Turn off the lighting source. The user must use it according to the requirements and go to the well before the miner\'s lamp goes out to ensure safety.